# Full mosfet class D power amplifier
# 2 input / mono channel input
# Low current consumption
# Low heat generation (performance more than 85%)
# Fully 1 ohm stable operation
# Two speakers operation
# RCA line out and input jack
# Crossover slope (24dB per Oct)
# Super bass control : 0-12db
# Variable subsonic flter (15Hz-40Hz)
# Variable low pass filter (40Hz-250Hz, 24dB per Oct)
# Wired remote control (optional 5 meter volume wire)
# Thermal, overload, short circuit and dc off-set protection
# Transparent power and speakers terminal
# 4 ohms maximum output @0.03% : 1800W RMS/1 ohm
# 4ohms bridget mono output @0.02% THD : 1200W RMS/2 ohms
# 2 ohms WRMS output @0.1 THD : 600W RMS/4 ohms
# Low pass filter : 40Hz - 250Hz
# Subsonic Filter : 15Hz-40Hz/Subsonic
# Frequency response : 20 - 500Hz
# Signal to noise ratio : 100dB
# Input sensitivity : 150mV - 2.5V
# Input impedance : 10Kohms
# Operation voltage : DC 12.4V
# Speaker impedance @ stereo driven : 1 Ohm Remote Control : Optional
# Fuse rating : 25Ax3
# Dimension (WHD) mm : 320x50x244
# Ultra stable pwm (pulse width modulated) mosfet power supply
# Top control with night illumination design
# 2 ohm stable operation with output power increase
# Built-in crossover top control
- Ch ½ : variable hi-pass filter (40hz-1khz)
- Variable low-pass filter (40hz-250hz)
- Ch ¾ : variable hi-pass filter (40hz-1khz)
- Variable low-pass filter (40hz-250hz)
# tri-mode capability for simultaneous hook-up of two stereo channels and subwoofer
# Super bass control : 0-12db
# Soft-start delay turn-on circuit
# Automatic remote on/off switching
# Power on and protect led indicators
# Built-in overload protection circuit
# Built-in over current protection circuit
# Built-in overheat protection circuit
# Gold plated rca input and terminals
